The Hydraulic De-coiler is used to hold and drive the steel coil that is being fed into the roll forming machine. The de-coiler allows for a quick change of steel coli with minimal manual labor. The de-coiler is powered with a feedback system that ensures the roll former is not required to turn the coil. The de-coiler will turn as required to reduce the potential for over coiling. Maximum coil mass: 10,000 kg

Nominal coil ID: 500mm supplied with addition spaces to use 600mm above

Maximum coil OD: 1300mm

Maximum coil width: 1300mm

Machine consists of the following major items:

Machine frame

Overhung shaft with roller bearing

Drive motor and chain

Hydraulic power pack (shared power pack on top /bottom coil)

Hydraulic cylinder of expansion/retraction

Solenoid valves

Electrical control system

Limit system to allow positioning of de-coiler for different feed positions. Manual positioning with position indicator.
Coiler Car-Powered loading bed to aid in loading to the de-coiler.

1300mm width Hydraulic steel coil Sheet Metal Decoiler

EPS Sandwich Panel Line

PU Sandwich Panel Line

Refrigeration Panels Making Machine

Rock Wool Sandwich Panel Line

Roll Forming Machine

Ceiling Panel Making Machine

EPS Molding Machine

Polyurethane Sandwich Panel Machine

Cleanroom Wall Panel Machine

SIP Panel Machine

Continuous Sandwich Panel Line

Phenolic Sandwich Panel Machine

Cold Room Insulation Material

Building Insulation Material

Portable Cold Rooms

1300mm width Hydraulic steel coil Sheet Metal Decoiler

4mm 4mm resistance welding machine

50mm rigid steel conduit

steel coil uncoiler